8/12/2023 0 Comments Replace synology drive![]() ![]() Within that dialog, you want to click on Repair. Within that sub-menu, go to the volume in question and click on Manage which should be at the top middle of the screen. Start with the Storage Manager menu and click on the Volume link on the left of the menu screen. This is part of the restoration process to put the RAID back into operational status. Testing the hard drive once installed is essentially a second test to run it through its paces. The system software will identify the test time length and confirm start. When ready execute the test with the Start button. For the first run, the extended test is preferred. Within the Health Info menu will be the S.M.A.R.T Test feature, and you can choose either a quick or extended test. You can see this in the HDD/SDD screen and the health info tab. Instead, run a Smart Test with the System and Storage Manager to check that the new drive is healthy and operating correctly. Replacing with a new drive is a simple matter of unpacking the new drive, physically connecting in the brackets and harness, and wiring up the drive to a power source and data connection. ![]() Drives up to terabytes in size are easy to obtain for low cost, and work exceptionally well, especially SSD types with solid-state flash memory and no moving parts. Step 4: If the drive cannot be repaired, replace itĪs noted above, the best path with a bad drive is to simply swap it out for a fresh new one. With new, replacement storage costs so affordable, the better approach is to simply razz the drive once the data is copied and physically destroy it to prevent any unauthorized recovery. However, any kind of drive that has been already giving off warnings and is old, as in at least two years or older, is likely getting ready to give up the ghost if it still runs. You could bench test it or, if you have the tools, inspect it internally. With the bad drive removed, it’s time to decide if it can be repaired. An extra step of prevention can save a lot of headaches. While some Synology NAS systems allow for operating removal or hot-swapping, don’t take the chance, even when doable. Doing otherwise could cause severe data shear and loss. Don’t go yanking out a drive until it is entirely shut down and turned off. This allows your system to be up and running instead of waiting for your diagnosis. Have a fresh drive ready and waiting to swap in when the bad one is pulled. With the bad drive identified, it’s time for shutdown and removal. Step 2: Shut down your NAS and remove the drive However, even when this says normal if the internal warning systems are triggered, the drive itself will still make audible noises such as buzzing or loud humming. In the Storage Manager, click on the HDD/SSD link on the left side.Ī list of the drives will display, and you can see their status as Normal in green, or Crashed or Failed in red letters. It looks like a silver barrel with a multi-color life-preserver ring in front of it. Once in the menu, click on the Storage Manager icon. Even if the sound is turned off, your system should be giving you Synology notices about the volume becoming degraded on the damaged drive and steps needing to be taken immediately.įrom the software, the failing drive can be identified under the DiskStation Manager and initiating the main menu button in the left upper corner of the screen. Look for the drive that is beeping audibly. The failing drive in a Synology system is easy to find. If the drive still works but is at risk of dying, copy as much of the data off it as possible before it fails. How to replace a failed hard drive in Synology NAS ![]() Data recovery off a dead drive could run in the thousands of dollars. If nothing at all, just accept that if the drive is entirely failed, the data may very well be lost. If not, then confirm where the data was backed up. If your system was utilizing a RAID approach, the data should be protected. ![]() Replacing a failed hard drive in a Synology NAS starts with first ascertaining your preservation status, essentially the system used for backing up your system data.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |